Services
Everything your instruments need, in one place.
Calibration, inspection, validation, repair and supply — the full working life of your measuring equipment, handled by one ISO 9001:2015 certified laboratory.
Calibration
We compare your instruments against reference standards and document the results, so you know exactly how accurate each one is — and when it's next due.
- Twelve disciplines, from pressure and temperature to torque, optical and force
- Portable instruments calibrated in our lab; installed and heavy equipment calibrated on-site
- A calibration certificate for every instrument, with results and next due date
- Calibration labels, so status is visible right on the instrument
Calibration disciplinesISO 9001:2015 scope
- 01Pressure
- 02Thermal
- 03Electro-technical
- 04Mass & weighing
- 05Volumetric
- 06Flow
- 07Dimensional
- 08Speed
- 09Optical
- 10Air velocity
- 11Torque
- 12Force
Inspection
Not every question needs a full calibration. Our inspection and testing checks condition and performance, so you can decide what to keep, adjust, repair or replace.
- Visual and physical condition checks
- Functional and performance testing at key points
- Clear findings and recommendations for your quality records
Sample inspection checklistPressure gauge
- Physical condition Good
- Functional check Pass
- Performance at test points Pass
- Pointer & dial Attention
RecommendationAdjust & calibrate
Validation & temperature mapping
Temperature-controlled equipment has to hold its set point evenly — everywhere inside it. We map temperature distribution with multiple sensors and report how uniform and stable it really is.
- Autoclaves and ovens
- Furnaces, muffle furnaces and hot cabinets
- Refrigerators and chillers
- Climatic and humidity chambers
- Temperature survey and mapping
Sample temperature mapAutoclave · 121 °C
9 sensors · 30 min holdSpread 0.7 °C
Repair
When an instrument fails or drifts out of tolerance, we find the fault, repair it and check it again before it goes back into service.
- Fault diagnosis and repair
- Adjustment and re-calibration after repair
- Advice when replacement makes more sense than repair
What we repair
- Electrical & thermal instruments
- Mechanical instruments
- General instruments
- Gas detectors
Supply
Need a new instrument or a replacement? Tell us the parameter, range and accuracy you need, and we'll recommend and supply a suitable instrument.
- Test and measuring instruments matched to your application
- Help choosing the right range, resolution and accuracy
- Calibration before delivery, on request
How supply works
- Tell us what you measure — parameter, range and accuracy
- Get a recommendation and a quote
- Receive your instrument, calibrated if you need it
FAQs
Questions we hear often
How often should instruments be calibrated?
Twelve months is a common starting point, but the right interval depends on how critical the measurement is, how heavily the instrument is used, how stable it has been in past calibrations, and what your quality system or customers require. We're happy to help you set sensible intervals.
Can you calibrate at our site?
Yes. Installed or heavy equipment — such as autoclaves, ovens, chambers, weighing balances and compression testing machines — is best calibrated where it stands. Portable instruments are usually calibrated in our lab.
What do I receive after calibration?
A calibration certificate for each instrument with the measured results and next due date, and a calibration label on the instrument itself.
My instrument isn't on your list. Can you still help?
Possibly. Send us the make, model and range — a photo of the nameplate is ideal — and we'll confirm whether we can calibrate it.
How do I get a quote?
Send your instrument list — instrument, make, range and quantity — on WhatsApp, by email, or through the enquiry form on our contact page. We'll reply with a quote and a schedule.
Get a quote
Ready when your instruments are
Send us your instrument list and we'll come back with a quote and a schedule that works for you.